
Old fence removal and replacement with new chain link
When an old wire fence sags, leans or has fallen in sections, patching it rarely lasts. We take it out along the line and build a new chain link fence in its place, as one job.
Old fence removal and replacement is the work of dismantling an existing wire fence – mesh, wires and posts – along its line, clearing the strip, and building a new chain link fence on fresh footings in the same position.
When is an old fence beyond repair?
In short: when posts are rotten or rusted at ground level, corners lean, or the mesh is torn and loose over long stretches.
A chain link fence fails from the structure outward. The usual signs are a corner post leaning into the field, intermediate posts snapped or rusted through at ground level, straining wires broken or missing, and mesh hanging in waves. Animals and vegetation then finish the job.
If only a few ties or one straining wire have gone, repair can make sense; our maintenance guide covers that. But when the posts themselves are failing, new mesh on old posts will sag again. At that point, replacing the fence is the honest advice.

Do we remove fences as a separate job?
In short: no – removal and line clearing are part of building a new fence, not a stand-alone service.
We take out old fences only when we are building the new one on the same line, or close to it. That way the removal is planned around the new posts and footings, and you deal with one contractor from start to finish.
If the old fence contains materials that need special handling – old corrugated asbestos-cement sheets used as fencing, for example – that is a job for a specialist. Our network partner retiradauralitamalaga.eu deals with that kind of material, and we build the new fence once it is gone.
What does removal and replacement include?
In short: taking down mesh and wires, extracting old posts, clearing the line, and building the new fence on new footings.
We cut the old ties and wires, roll up the mesh, and pull or cut out the old posts. Old concrete footings that are in the way are broken out; ones that are not can sometimes stay buried. Then the strip is cleared of scrub and roots so the new line can be set out properly, as described in clearing the fence line.
The new fence is built as on any other job – setting out, footings, braced posts, straining wire and mesh. You choose the new fence freely: galvanised chain link, coated mesh, or mesh on a low wall.

Should the new fence follow the old line?
In short: only if the old line is the agreed boundary – replacement is a good moment to confirm it.
Old fences were sometimes built where it was convenient, not exactly on the boundary. Before we set out the new fence, confirm with your neighbour, or with a surveyor if needed, that the old line is correct. Moving a new fence later costs far more than checking first.
Replacing a fence on the same line, with the same use, may also be treated differently by the ayuntamiento from a completely new fence. Ask before work starts; our guide to permits for rural chain link explains what to check.
What happens to the old material?
In short: it is collected and taken away as part of the job, so the plot is left clear.
Old mesh, wire and posts are bulky but mostly metal. We collect them along the line and remove them from the property together with offcuts from the new fence. The handling of old material is listed in the quote, so it is not a surprise at the end.
Our price site has a guide on old fence removal and waste that explains how this item usually appears in quotes.
What affects the cost of replacing a fence?
In short: the condition and type of the old fence, the old footings, vegetation along the line, and then the usual new-fence factors.
An old fence buried in brambles takes longer to remove than one on clear ground, and old concrete footings take longer than posts driven into soil. After that, the new fence is priced like any other: length, corners, terrain, access and specification. For general reading, see presupuestovalla.eu.
How we build it – step by step
- Assessment
From photos or a visit, we look at the old fence, its posts and footings, and the vegetation along it.
- Confirming the line
You confirm that the old line is the agreed boundary, or tell us where the new fence should run.
- Dismantling
We cut ties and wires, roll up the old mesh and take out the old posts.
- Footings and clearing
We break out old footings that are in the way and clear the strip of scrub and roots.
- New footings and posts
We set out the new line, dig the holes and set and brace the new posts.
- Wire and mesh
We run and tension straining wires, then hang and tension the new mesh.
- Removal of material and clean-up
We collect the old material and offcuts and remove them from the property.
When is it the right choice – and when not?
A good fit if…
- Fences with failing posts or leaning corners
- Mesh that is torn or sagging over long stretches
- Fences overgrown with scrub along most of the line
- Owners who want a new fence type on the same boundary
Consider another option if…
- A fence with a few loose ties – repair is enough
- Removal without a new fence – we do not offer that
- Asbestos-cement sheets – a licensed specialist must remove them first
- Boundaries still in dispute
What affects the cost?
We don't publish fixed prices: every fence is quoted line by line using these factors.
- Length of old fence to remove
- Type and condition of old posts and footings
- Vegetation along the line
- Removal of old material from site
- Length and type of the new fence
- Corners and braced posts
- Terrain and access
- Licence or notice fees
Articles and guides

Fencing land with chain link: plots, terraces and fincas
Fencing a plot or finca is mostly about the ground: slope, rock, scrub, access and long straight runs. We plan the line around those conditions and build a chain link fence that stays tight across the whole boundary.
View details →Posts and tensioning: the structure behind a chain link fence
Chain link mesh has no strength of its own. Whether a fence stays tight or sags depends on the posts, their footings, the braces and the straining wires – the part most people never look at.
View details →
Clearing the fence line before building chain link
On rural land the line of a new fence is often buried in brambles, gorse or young trees. Clearing it is the first real job on site, and we do it as part of building the fence.
View details →
What can go wrong while a chain link fence is being built?
Most chain link jobs go to plan. When they do not, it is usually for the same handful of reasons. Knowing them in advance makes the conversation easier if one comes up.
View details →Frequently asked questions
Can you just remove my old fence?
No. We remove old fences only as part of building a new fence on the same line or close to it.
Can you reuse my old posts?
Rarely. If the posts are failing, reusing them undermines the new fence. Sound posts are assessed case by case.
Can the new mesh be hung on the old posts?
Only if the posts and footings are sound and correctly braced. In many old fences they are not.
What do you do with the old footings?
We break out the ones that are in the way of the new line. Others may stay buried if they do not interfere.
Is my old fence asbestos?
Wire mesh is not, but some old boundaries use corrugated asbestos-cement sheets. Those must be removed by a specialist before we build.
Can the new fence be a different type?
Yes. You can switch to coated mesh, mesh on a low wall, or another fence type entirely.
Do you clear brambles along the fence?
Yes, the strip needed for the new fence, as part of the job.
Will removal damage my garden?
We work along the line and keep disturbance to the strip around it. Tell us about plants or irrigation you want protected.
Do I need a permit to replace a fence?
It depends on the ayuntamiento. Replacement may be treated differently from a new fence, so ask before starting.
Can I see the old fence removed before deciding on the new one?
We quote both together, because the removal is planned around the new line. You can still choose the new fence type before work starts.
Send photos of your boundary
Photos and an approximate length are enough to start. We measure, then send an itemised quote with no commitment – even if you are not in Spain.